Maintenance Every Day; Clean The Machine; Check The Engine Oil Level - Fayat BOMAG BT 60 Operating And Maintenance Instructions Manual

6.6 Maintenance every day

6.6.1 Clean the machine

Fig. 35

6.6.2 Check the engine oil level

NOTICE!
Perform cleaning work only after the engine has
cooled down and with the engine stopped.
Dirty operating conditions, particularly lubrication oil
and fuel deposits on the cooling fins of the engine and
the cooling air intake opening have an adverse effect
on the cooling of the engine.
You should therefore immediately seal any oil or fuel
leaks near fuel tank, cylinder or cooling air intake.
NOTICE!
Do not guide the water jet into the air intake and the
recoil starter Ä Fig. 35.
After wet cleaning run the engine warm to evaporate all water
residues and to avoid corrosion.
NOTICE!
Check the engine oil level with highest care, to avoid
over or underfilling of the engine. Underfilling can
damage the engine. Overfilling causes excessive
development of smoke and can also lead to engine
damage
The engine cannot be started if the engine oil level is
too low.
For quality of oil refer to the "table of fuels and lubri-
cants".
Stand the tamper on flat and level ground.
Shut down the engine.
BT 60 / BT 65
Maintenance
49