Engine Problems - Fayat BOMAG BT 60 Operating And Maintenance Instructions Manual

Vibratory tamper
Table of Contents

Advertisement

7.2 Engine problems

Fault description
Engine does not start
Engine does not crank when oper-
ating the recoil starter
Starter rope of recoil starter does not
return to initial position
Engine stops frequently in short
intervals
Engine does not run with full speed
Engine runs with high speed, but no
vibration
Cause
Fuel tank empty
Fuel system clogged
Fuel nozzle clogged
No ignition spark
Engine oil level too low
Set the engine stop
switch to position "OFF"
Engine stop switch
defective
No fuel in carburettor
Recoil starter defective
Spring broken
Recoil starter dirty
Spring broken
Fuel system clogged
Throttle cable defective
Throttle cable incor-
rectly adjusted
Air filter clogged
Too high engine oil level Check the engine oil level, if necessary
Exhaust blocked
Engine defective
Carburettor defective
Centrifugal clutch defec-
tive
Mechanical defect
BT 60 / BT 65
Trouble shooting
Remedy
Check the fuel level, top up if necessary.
Clean the fuel screen in the tank
Replacing the fuel filter
Clean the fuel screen in the carburettor
Clean the fuel nozzle
Clean the spark plug, replace if neces-
sary
Check the engine oil level, correct if nec-
essary
Set the engine stop switch to position
"ON"
Replace the engine stop switch
Check the fuel supply
Replace the recoil starter
Replace the recoil starter
Clean the recoil starter
Replace the recoil starter
Clean the fuel screen in the tank
Replacing the fuel filter
Clean the fuel screen in the carburettor
Replacing the throttle cable
Adjust the throttle cable
Clean the air filter, replace if necessary
drain off engine oil to the "MAX" mark
(Clean the air intake manifold)
Clean the exhaust
Have examined by a specialist
Have examined by a specialist
Replacing the centrifugal clutch
Have repaired by our customer service.
75

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bomag bt 65

Table of Contents