Table of Contents
Advertisement
5.7 Changing the tamper foot
plate
Fig. 28
After changing the tamper foot plate (Fig. 28)
l
tighten the 4 fastening screws with a tightening
torque of 60 to 70 Nm (44 to 52 ft.lbs).
i
Note
When changing the tamper foot to a different width
use only genuine BOMAG parts.
After changing the tamper foot check the engine
speed, adjust it if necessary.
BT 60/4, BT 65/4
5.8
Loading/transport
Danger
!
Danger of accident! Life hazard!
Always shut the engine down to transport the
tamper or to lay it on its side.
Make sure that persons are not endangered by
the machine tipping or sliding off.
Lifting tackle must only be attached to loads
by expert personnel (qualified person).
Use only safe lifting gear of sufficient load
bearing capacity Minimum lifting capacity of
lifting gear: see operating weight in chapter
"Technical Data".
Fasten the lifting gear only at the specified lift-
ing points.
Check all lifting and lashing points for damage
before lifting or lashing down the machine. Do
not use a damaged or in any other way im-
paired lifting and lashing eyes.
Do not lift or lower the machine jerkily.
The tension must always be effective in verti-
cal direction.
The machine must not swing about when be-
ing lifted.
Do not step or stand under suspended loads.
Always use suitable lashing gear on the lifting
points to lash down the machine.
Lash the machine down, so that it is secured
against rolling, sliding and turning over.
BOMAG
Operation
31
Hide quick links:
Advertisement
Table of Contents
