5.6 Connecting the dark boxes of the first row
Barco - OV-508/OV-513/OV-515– R5990099 – installation manual – revision 01– November 2007 ________________________________
When all the darkboxs of the first row of all columns
are installed,
Level the system.
Subsequently connect the columns.
It is always one connection kit on the front side and
one connection kit at the rear side.
Linear connection kit: The screws are of type M6x55
and fixed via nuts and washers.
At the front, there is a top and a bottom fixation
facility, both providing two holes. Use one of the
holes of the top and one of the holes of the bottom
fixation facility and apply 2x one screw M6x55 and
fix it via nuts and washers.
On the rear side, there is only one hole to connect
two darkboxes in a linear setup. Apply the screw and
fix it via nuts and washers.
________________________________________________
________________________________
________________________________
5. Installation
Step 26
Step 27
________________ 25
________________
________________