Table of Contents
Advertisement
5.13 Installation of the illumination unit
Barco - OV-508/OV-513/OV-515– R5990099 – installation manual – revision 01– November 2007 ________________________________
Seen from front, the illumination unit is located at
the right side.
The illumination unit houses the two lamps and the
filter cartridge as well as control elements and the
LCD to display system information.
The fixation facilities allow mounting the device into
4:3 systems and into 5:4 systems: Depending on the
height of the module, the bottom fixation of the
device uses the upper (SXGA systems) or the lower
(XGA, SXGA+) keyhole.
The engine support profile comes already with the
pins to hang on the illumination unit and the screws
to fix it.
Remove the respective screws from the engine
support profile, hang the illumination unit onto the
pins and slid the screw of the rear bottom profile into
the keyhole.
Tighten the screws.
________________________________________________
________________________________
________________________________
5. Installation
Step 44
Step 45
________________ 43
________________
________________
Advertisement
Table of Contents
