Table of Contents
Advertisement
Installation
2.4 Connecting the Display
How to set up the Display
1. Be sure all equipment is turned off.
2. Connect the DC plug to the power connector on the monitor and the other end into an electrical outlet.
3. Connect the D-SUB or DVI cable from the display's D-SUB or DVI input connector to the D-SUB or DVI
connector of your host computer and tighten the screws.
4. Connect the USB cable from the USB port of your display to the USB port of your computer.
5. Configure the touch screen. Refer to the "Touch Screen Driver Installation" section of this user guide.
6. Once the touch screen is configured, the monitor is ready for use.
External power supply applicable: Bridgepower BPM050S12F09
To ensure the LCD display works well with your computer, please configure the display mode of
your graphics card to make it less than or equal to 1920 x 1080 resolution and make sure the timing
of the display mode is compatible with the LCD display.
12
R5911667 /03
AMM215WTTP
Advertisement
Table of Contents
Troubleshooting
