First Time Starting Up - Barco Nio 5MP LED User Manual

2. Installation
5. Remove the four screws fixing the foot while supporting the foot.
Image 2-13
6. Attach the arm stand firmly to the panel using 4 screws M4 x 8 mm.
2.4

First time starting up

Overview
You are now ready to start up your Nio 5MP LED Display for the first time.
1. Switch on your Nio 5MP LED Display as described in "Standby switching", page 14.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is finished.
Your Nio 5MP LED Display will be running in a basic video mode at a default refresh rate
when first time starting up. If you are using a Barco display controller, please consult
the user guide delivered with it to install the drivers, software and documentation. When
this is done, your display will automatically detect the connected video input signal(s)
and apply the correct video mode and refresh rate.
12 K5902121 NIO 5MP LED DISPLAY 18/01/2018