7.4 A-shape version
The length of the profile is project specific and defined by the distance between the rear
side of the display wall and the wall of the building!
The attachment of the profile on the wall of the building allows to be positioned between
30degrees and 60degrees off the straight connection thus also eliminating unevenness of
the wall.
An assembled A-shape version looks like this:
First install the bracket to the dark box, then the legs, subsequently apply the short horizontal profile, then the
brackets to be fixed to the wall of the building.
In case of a curved setup, the A-shape version is fixed via the center screws (2 screws only),
fixed to the polygonal connection bracket, whereas for a linear setup the left and the right
screws are used (4 screws), fixed to the profiles.
Barco - OV-508/OV-513/OV-515– R5990099 – installation manual – revision 01– November 2007 ________________________________
________________________________________________
________________________________
________________________________
7. Wall attachment
________________ 64
________________
________________