Table of Contents
Advertisement
The horizontal movement screws of all screens right to the static screen look in the same
direction.
The horizontal movement screws of all screens left from the static screen also look in the same
direction, but opposite to the horizontal movement screws of the screens right to the static
screen.
Never drill only one of the horizontal movement screws completely out before turning the
seconed!
Make several turns on one screw and than go to the second, turn it, go back to the first ...
continue until the gap is closed.
Barco - OV-508/OV-513/OV-515– R5990099 – installation manual – revision 01– November 2007 ________________________________
All other screens of the bottom row are installed
following the procedure below:
Apply the 4x2 screws to block the vertical movement.
Screw in the horizontal movement screws until the
screen front is moved approx. 1mm against the
vertical frame towards the horizontal movement
screw.
Hang the screen on the pins. Make sure that the
horizontal movement screws always show towards
the border of the display wall – this means that the
left neighbor of the static screen is rotated by 180°
compared to the right neighbor of the static screen.
Lock the 4 securing screws from behind.
After locking the screen there will be a screen gap to
the neighbored screen of around 1mm.
To close this gap, drill out (turn left) the horizontal
movement screw.
The screen is now moving and the gap will be closed.
Completely remove the horizontal movement screws!
________________________________________________
________________________________
________________________________
5. Installation
Step5
Step6
Step7
Step8
________________ 38
________________
________________
Advertisement
Table of Contents
