Finalizing The Cabling - Barco OV-508 Installation Manual

5.15 Finalizing the cabling

Barco - OV-508/OV-513/OV-515– R5990099 – installation manual – revision 01– November 2007 ________________________________
Power:
Plug in the power cord to the IEC320 interface of the
illumination unit [1].
In case the display module is equipped with a Multi
Input Module:
Plug in the power cord to the IEC320 interface of the
Multi Input Module.
Use the cable included in the Multi Input Module to
connect the IEC320 interface [1] of the illumination
unit to the AC out interface of the Multi Input Module.
I2C Communication:
Plug the interconnection cable into the I2C interface
[2] of the illumination unit and of the projection unit
[I2C].
Digital sources are connected to DVI 1 IN and/or
DVI 2 IN. DVI 1 IN is loop-through to DVI 1 OUT,
DVI 2 IN is loop-through to DVI 2 OUT.
In case a source has to be displayed on additional
projection modules, connect the respective DVI
output with one of the DVI inputs of the other
projection module
LAN Subnet
The projection modules are controlled via a web
application. All projection units are connected in a
subnet via LAN switches.
One LAN switch serves 6 projection modules. The
cable layout depends on the actual configuration.
In case the display wall is 6 modules in height, one
column is connected to the switch, otherwise
multiple columns are connected to the switch. During
installation, the position of the switch has been
selected to minimize distances, cf. .Step 08
________________________________________________
________________________________ ________________________________
5. Installation
Step 53
Step 54
________________ 47
________________ ________________