EMC VNX Series Hardware Information Manual page 93

Inter Connect Module (ICM)
Power Supply Module
E
D
C
B
A
0 1
Cooling Module
Figure 83 4U, 60 DAE disk drive layout and notation (top-down interior view)
Rules for disk drive population
To load the disk drives into a 4U DAE is
1. Start at row (or bank) A, slot 0.
2. Fill up row (or bank) A before inserting any disk drives into row B.
3. Continue this order until you fill all the rows with row E being the last row filled.
Note: If a partially filled row is available, the remaining empty slots are to be loaded with
filler panel modules. Rows with no or zero (0) drives do not require filler panel modules.
Spare filler panel modules do not have to be placed into specific slots, but they must be
placed in the same row.
Rear of 4U DAE
Power Supply Module
2 3 4 5 LCCA 6
Cooling Module
Front of 4U DAE
(Figure 83):
VNX5500 Hardware Information Guide
Disk-array enclosure
Inter Connect Module (ICM)
Disk drive
LCC B
7 8 9 10 11
LCC A
Cooling Module
VNX-000650
93