EMC VNX Series Hardware Information Manual page 38

System component description
Control Station rear view
38 VNX5500 Hardware Information Guide
2
Figure 29 Example of SP with a Fibre Channel (FC) I/O module and an iSCSI I/O module
For a full description of the I/O module types used in the SP, go to the
section on page 47.
On the rear, viewing from left to right, the Block and File (Unified) VNX5500 platform
Control Station includes the following hardware components:
AC (power in) recessed connector (plug)
◆
Two PS/2 connectors (keyboard and mouse)—not used
◆
One (DB-9 plug) serial modem connector
◆
One (DB-15) video (VGA socket) connector—not used
◆
Four (RJ-45) NIC (labeled A, CS, B, and MGMT) connectors
◆
Note: The RJ-45 NICs (labeled A and CS) are integrated into the rear of the Control
Station while the RJ-45 NICs (labeled B and MGMT) are on a PCI-E card in the
expansion slot on the rear of the Control Station.
One (DB-9 plug) serial console (RS-232/EIA-232) connector
◆
Two USB 2.0 connectors—not used
◆
POST diagnostic LEDs
◆
Two CAT-5E/6 panel-mount Ethernet cable extensions
◆
SP I/O Module Slots
PART NUMBER
REV A09 A
8Gb 6Gb
fibre SAS
1
4 5
3
PART NUMBER
REV A09 A
X4
6Gb SAS
0 X4
VNX-000569
"I/O modules"