EMC VNX Series Hardware Information Manual page 42

System component description
42 VNX5500 Hardware Information Guide
If your VNX5500 includes a second optional 1U Control Station (CS 1), another set of
Ethernet cable extensions for the RJ-45 ports is provided. These cables allow you to
extend the length of the Ethernet cables from the CS 1, port B to Data Mover enclosure 0,
management module B, port 2 and CS 1, MGMT port to the public LAN. Each cable
includes a corresponding label clip to assist you during system cabling.
Note: If you received the Block and File (Unified) VNX5500 platform already installed in a
EMC cabinet rack with all the Block and File (Unified) VNX5500 platform components, all
the cabling has already been installed.
Figure 33 Example of an Ethernet extension (modular plug to modular jack) cable
Control Station serial console (DB-9) plug connector
The rear of the Block and File (Unified) VNX5500 platform 1U Control Station includes a
standard serial console Electronics Industries Association (EIA) RS-232 interface (DB-9)
plug connector (labeled with a wrench tool icon on the right). Notice the orientation of the
pins (Figure 34).
Pin 1 5
6
9
CNS-001742
Figure 34 Control Station serial console (DB-9) plug connector
Table 24 lists the 1U Control Station Ethernet (DB-9) pin signals used on the connector.
Table 24 Control Station (DB-9) plug connector pinout
DB-9 Pin Signal
1 CD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Description
Carrier detect
Received data
Transmitted data
Data terminal ready
Ground
Data set ready
Request to send
Clear to send
Ring indicator (not used)
VNX-000564