EMC VNX Series Hardware Information Manual page 29

Table 12 SP LEDs (continued)
Led Color
Fault Amber
(location 11)
—
Power Green
(location 12)
—
SP Input/output ports and connectors
The Block and File (Unified) VNX5500 platform SP supports the following I/O ports on the
rear:
Two 6-Gb/s SAS PCI Gen 2 x4 ports (labeled 6Gb SAS 0 x4 and 1 x4); supported
◆
speeds are 1.5, 3, and 6 Gb/s
Four 8-Gb/s Fibre Channel (FC) ports (for front-end connectivity)
◆
One Ethernet (RJ-45) 10/100/1000 LAN (management) port
◆
One Ethernet (RJ-45) 10/100/1000 LAN (service laptop) port
◆
One RS-232/EIA 232 (micro DB-9) SPS connector
◆
One RS-232/EIA 232 (micro DB-9) service laptop connector
◆
6-Gb/s SAS x4 ports — The Block and File (Unified) VNX5500 platform SP supports two
6-Gb/s SAS x4 ports (labeled 6Gb SAS 0 x4 and 6Gb SAS 1 x4) on the rear of each SP (A
and B). These ports provide an interface for SAS and NL-SAS drives on the DAE. Each port
is a 26-circuit SAS small form-factor 8088 (SFF-8088) specification (socket or receptacle)
using an SFF-8088 specification mini-SAS 26-circuit cable (plug) with a pull tab.
Note: Each SAS cable is keyed with an
Figure 18 shows an example of the port connector (socket) and cable connector (plug)
with pull tab.
Pin A1 A13
B1 B13
Figure 18 SP 6-Gb/s SAS port and cable connector
State Description
On Fault
Off No fault or power off
On Power on
Off Power off, verify connection
in out
and connection to prevent incorrect cabling.
VNX5500 Hardware Information Guide
System component description
VNX-000094
29