EMC VNX Series Hardware Information Manual page 39

Figure 30 shows the orientation of the CS components.
1
1 AC (power in) recessed connector (plug)
2 PS/2 connector (mouse)—not used
3 DB-9 serial modem plug connector
4 RJ-45 Ethernet NIC port (labeled CS
5 RJ-45 Ethernet NIC port (labeled B)
6 RJ-45 Ethernet NIC port (labeled MGMT)
1. The CS port uses an IPMI (Intelligent Platform Management Interface) cable to connect to a standby Control
Station).
2. These LEDs might light during power on self test (POST); they are not important for the administration or
maintenance of the Control Station.
3. An extension cable with a label (CS 0 B) is provided with this connector (see the cable kit).
4. An extension cable with a label (CS 0 MGMT) is provided with this connector (see the cable kit).
Figure 30 VNX5500 platform Control Station (rear view)
Control Station Input/output ports and connectors
The Block and File (Unified) VNX5500 platform 1U Control Station supports the following
I/O ports on the rear of the 1U Control Station:
Four Ethernet (RJ-45) NIC ports
◆
One serial modem (DB-9) plug connector
◆
One serial console (DB-9) plug connector
◆
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution
when connecting cables.
2 3
12 11
10
7
8
9
1
) 10
3
11
4
12
VNX5500 Hardware Information Guide
System component description
4 5 6
CS
B MGMT
A
9 8
DB-9 serial console plug connector
Two USB 2.0 connectors (not used)
RJ-45 Ethernet NIC port (labeled A)
2
POST diagnostic LEDs
DB-15 Video (VGA) socket connector—not
used
PS/2 connector (keyboard)—not used
7
CNS-001741
39