EMC VNX Series Hardware Information Manual page 23

SPS LEDs
Note: If an SPS is cabled with the SPS sense (management) cable going to the power
supply on SP A and the power-out cable going to the power supply on SP B (or the other
way around), an error condition will occur when the SPS is tested or when it is charging.
Looking from left to right,
and A, respectively).
1 2
SPS B (optional)
1 SPS B AC (power in) recessed connector
(plug)
2 Power out socket
3 Power out socket to the SP B power supply
on the DPE
4 SPS A AC (power in) recessed connector
(plug)
5 Power out socket to the SP A power supply
on the DPE
Figure 11 Example of SPS B and A viewing from left to right (rear view)
Figure 12 shows the LEDs located on each SPS (A and B).
SPS power
SPS battery
SPS no battery
SPS fault
VNX-000289
Figure 12 SPS LEDs
Figure 11 shows an example of the rear view of a dual 1U SPS (B
3
S/N
900-XXX-0014 0082
REV A00
SPS A
10 9
6
7
8
9
10
VNX5500 Hardware Information Guide
System component description
4 5 6
Power out socket
Four SPS A status LEDs (green and amber)
SPS A to SP A management (RJ-12)
connector
Four SPS B status LEDs (green and amber)
SPS B to SP B management (RJ-12)
connector
S/N
900-XXX-0014 0082
REV A00
8 7
VNX-000282
23