EMC VNX Series Hardware Information Manual page 73

Hide thumbs Also See for VNX Series:
Table of Contents

Advertisement

Power supply
Cooling modules
EMI shielding
Inter Connect Module (ICM) expander on the same side (A or B) of the 4U DAE is available.
Each expander manages the drives it is connected to. The only shared resources are the
LCC LED and the expander I
In a 2U or 3U DAE, the power supply/cooling module integrates independent power
supply and blower cooling assemblies into a single module.
Each power supply is an auto-ranging power-factor-corrected, multi-output, off-line
converter with its own line cord. The drives and LCC have individual soft-start switches
that protect the disk drives and LCC if you install them while the disk enclosure is
powered up. A disk or blower with power-related faults will not affect the operation of any
other device.
In a 2U or 3U DAE, each power/cooling module has three status LEDs
page 77
and
Figure 73 on page
In a 4U DAE, the power supplies
modules are separated and located at opposite ends of the 4U DAE. The power supplies
are located on the rear of the 4U DAE while the cooling modules or fans are located on the
rear of the 4U DAE. The power supplies can be installed/removed from the rear of the DAE
while the cooling modules or fans can only be installed/removed by sliding the DAE
forward, then sliding the DAE cover to the rear. You access the cooling modules or fans
from the inside of the DAE (see the
section on
page 89
for more information).
In a 2U or 3U DAE, the enclosure cooling system consists of dual-blower modules in each
power supply/cooling module.
In a 4U DAE, the cooling modules are separate from the power supply modules.
EMI compliance requires a properly installed electromagnetic interference (EMI) shield in
front of the DAE disk drives. When installed in cabinets that include a front door, the DAE
includes a simple EMI shield. Other installations require a front bezel that has a locking
latch and integrated EMI shield. You must remove the bezel/shield to remove and install
the disk drives.
2
C (inter-integrated circuit) bus.
83).
("4U, 60 DAE AC power supply" on page
"Access to disk drives, LCCs, and cooling modules"
VNX5500 Hardware Information Guide
Disk-array enclosure
(Figure 66 on
102) and cooling
73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vnx5500

Table of Contents