EMC VNX Series Hardware Information Manual page 69

Two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module
The two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module (labeled 10 GbE Base-T on the
latch handle) comes with two 10-Gb/s Base-T copper (RJ-45) ports, one power/fault LED,
and a link and activity LED for each port
can interface at speeds of 10 Gb/s for iSCSI networks. The two-port 10-Gb/s Base-T I/O
module uses EIA Category 6 or 6a Unshielded Twisted Pair (UTP) or EIA Category 7 fully
Shielded Twisted Pair (STP) copper cabling (for more information about these types of
cables, see Table 16, "Ethernet cabling guidelines,"
cabling guidelines," on page
Note: The two-port 10-Gb/s Base-T I/O module requires VNX OE for file version 7.1 or later.
1 2
3
4
5
VNXe-000751
1 Push button latch handle
2 Power/fault LED
3 RJ-45 Base-T port (2)
Figure 62 Two-port 10-Gb/s Base-T I/O module
(Figure 50). The Base-T ports on this I/O module
on
40).
4 Link LED (right)
5 Activity LED (left)
VNX5500 Hardware Information Guide
I/O modules
page 34 or Table 21, "Ethernet
69