EMC VNX Series Hardware Information Manual page 65

Note: This I/O module requires software release VNX OE for File 7.0 to function properly. It
will not function properly in software release VNX OE for File 7.1. Use the newer I/O
module (version 3) of the two-port 10-Gb/s Ethernet optical or active Twinax I/O module
as described in the "Two-port 10-Gb/s optical I/O module"
1 2
3
4
5
CNS-001756
1 Push button latch handle
2 Power/fault LED
3 SFP+ (optical) port (two)
Figure 58 Two-port 10-Gb/s optical I/O module
Two-port 10-Gb/s optical I/O module LEDs
The two-port 10-Gb/s optical I/O module has three types of status LEDs.
the LEDs and Table 37 on page 66
Power/fault LED
Link LED
Activity LED
Link LED
Activity LED
Figure 59 Two-port 10-GbE optical I/O module LEDs
4 SFP+ link LED (right)
5 SFP+ NIC activity LED (left)
describes them.
CNS-001672
VNX5500 Hardware Information Guide
I/O modules
section on page 66.
Figure 59 shows
65