EMC VNX Series Hardware Information Manual page 49

Four-port 1-Gb/s copper iSCSI I/O module
Four-port 8-Gb/s FC I/O module LEDs
The four-port 8-Gb/s Fibre Channel (FC) I/O module has two different types of status LEDs.
Figure 41 shows the LEDs and
Power/fault
LED
Link/Activity
LED
Link/Activity
LED
Link/Activity
LED
Link/Activity
LED
Figure 41 Four-port 8-Gb/s FC I/O module LEDs
Table 28 Four-port 8-Gb/s FC I/O module LEDs
LED Color
Power/Fault Green
Amber
—
Link/Activity Green
(each port
Blue
has one LED)
Green or
Blue
—
1. Refer to the VNX5500 Parts Location Guide
The four-port 1-Gb/s copper iSCSI I/O module (labeled 1 GbE iSCSI/TOE on the latch
handle) comes with four 1 Gb/s Ethernet Base-T copper ports, one power/fault LED, and a
link and activity LED for each copper port
at speeds of 1 Gb/s. The 1 Gb/s Ethernet Base-T copper ports connect to Cat 6 cabling
(see Table 16, "Ethernet cabling guidelines,"
guidelines," on page 40) to an Ethernet switch. This I/O module also includes a TCP
offload engine (or TOE).
Table 28 describes them.
CNS-001670
State Description
On I/O module is powered up.
On I/O module has faulted.
Off I/O module is powered down.
On 2- or 4-Gb link speed (suboptimal speed)
On 8-Gb/s link speed (maximum speed)
Blinking Small form-factor pluggable (SFP+
faulted, unsupported, or optical cable fault.
Off No network connection
for the part number label location for the SFP+ part number.
(Figure 42). This iSCSI I/O module can interface
on page 34
VNX5500 Hardware Information Guide
I/O modules
1
) transceiver module
or Table 21, "Ethernet cabling
49