EMC VNX Series Hardware Information Manual page 37

Pin 1
5
6 9
VNX-000105
Figure 28 SP serial RS-232/EIA 232 (micro DB-9) connector (socket)
Table 20 lists the SP serial RS-232/EIA 232 (micro DB-9) pin signals used on the
connector.
Table 20 Serial RS-232/EIA 232 (micro DB-9) connector (socket) pinout
DB-9 Pin Signal
1 CD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
SP I/O module slots
Two SP PCI-E x2 I/O module slots are available. These slots
support the following I/O modules:
Two-port 10-Gb/s optical or active Twinax (w/iSCSI protocol)
◆
Four-port 1-Gb/s copper iSCSI
◆
Four-port 8-Gb/s optical Fibre Channel (running at 2, 4, or 8-Gb/s)
◆
Two-port 10-Gb/s optical or active Twinax Fibre Channel over Ethernet (FCoE)
◆
Note: The two-port 10-Gb/s FCoE I/O module requires VNX OE for File version 7.0.35.3
or later.
Two-port 10-Gb/s Base-T iSCSI/IP
◆
Note: The 10-Gb/s Base-T I/O module requires VNX OE for File version 7.1 or later.
Four-port 6-Gb/s SAS
◆
Description
Carrier detect
Received data
Transmitted data
Data terminal ready
Ground
Data set ready
Clear to send
Request to send
Ring indicator
VNX5500 Hardware Information Guide
System component description
(Figure 29 on page 38)
37