Metal core drilling
Removal
8.5.5 Removing the shaft
Steps that must be completed:
-
Removing the electronics
-
Removing the drill motor
-
Removing the gearbox housing
-
Removing the holder
-
Removing the shaft
Tools:
-
Circlip pliers
-
Arbor press
-
Sleeve 39 mm inner diameter
46 mm outer diameter
1
C-SC_CSSM
1.
2.
Version 1.0
All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation.
Remove the circlip (1).
Press down on the grooved ball bearing (2).
11.02.2019
Page 47 of 88