Ingeteam Ingecon Sun Power Series Installation Manual page 16

Ingeteam Power Technology, S.A.
When transporting Ingecon
being returned to the factory.
If the equipment has to be moved, be aware that the centre of gravity of these units is at the centre of its vertical
projection and at 1/3 of its height.
Transport using goods vehicles
During transport Ingecon
®
with their weight and size to avoid tipping and bumps.
Transport using a forklift truck
At least the following requirements should be observed:
1. Place the packaged unit centred with respect to the forks.
2. Try to locate it as close as possible to the connection between the forks and the chassis.
3. Ensure that the forks are perfectly level to avoid overturning the unit.
4. In any case, observe the instructions in the forklift truck's user manual.
5. If it is transported after having been unpacked, unscrew the base being moving it.
Transport using a crane
When lifting by crane, the lifting eyes fitted to the top corners of the cabinet should be used, as shown below.
Ensure that the load is distributed evenly between the eyes by fixing individual cables, chains or ropes to each of the
eyebolts, taking into account that the angle formed by each pair of cables on the same side is less than or equal to
45° and ensuring that the cables are as vertical as possible.
It is always advisable to use a load frame as in the adjoining figure for a proper distribution of the loads, bearing in
mind that the angle φ should be equal to 90°.
14
Sun Power units it is essential to maintain the unit in the upright position, even if it is
®
Sun Power units must be kept in an upright position and properly secured in accordance
Installation manual
AAS2000IKI01