How To Turn The Power On Or Off - Furuno NavNet TZtouch3 Series Operator's Manual

1. SYSTEM INTRODUCTION
1.3

How to Turn the Power On or Off

How to turn the power on
Tap (push for TZT12F) the power switch (
the front panel to turn the power on.The equip-
ment beeps twice and the splash screen appears.
After the startup process is completed, the wel-
come screen replaces the splash screen.
[Demo Mode]: Tap [Start] to start the Demo mode. To stop the Demo mode, go to the
Home screen, tap [Settings]→[General], then [Stop Demo].
[Let's Navigate!]: Start normal operation. (The equipment starts up with the last-used
display.)
[Tutorial]: Tap [Start Tour] to start the tutorial. You can stop the tutorial at any time by
tapping the screen. A confirmation message appears; tap [OK] to stop the tutorial.
[Show at startup]: Check to get the welcome screen each time the equipment is pow-
ered. Remove the checkmark to hide the welcome screen at power-up. You can also
show or hide the welcome screen from the menu.*
After clearing the welcome screen, the [NAVIGATION WARNING] screen appears.
Read the warning, then click [OK].
* To show or hide the welcome, go to the Home screen, tap [Settings]→[General], then
turn [Show Welcome Screen at startup] on or off.
1-12
) on
TZT16F/19F
TZT12F
Power
switch