How To Turn The Power On Or Off - Furuno NAVnet TZtouch2 Operator's Manual

1.3

How to Turn the Power On or Off

The Power switch (
When you turn on the power, he equipment beeps twice and the splash screen ap-
pears. After the startup process is completed, the welcome screen replaces the splash
screen.
[Demo Mode]: Tap [Start] to start the Demo mode. To stop the Demo mode, go to the
Home screen, tap [Settings][General], then [Stop Demo].
[Let's Navigate]: Start normal operation. (The equipment starts up with the last-used
display.)
[Tutorial]: Tap [Start Tour] to start the tutorial. You can stop the tutorial at any time by
tapping the screen. A confirmation message appears; tap [OK] to stop the tutorial.
[Show at startup]: Check to get the welcome screen each time the equipment is pow-
ered. Remove the checkmark to hide the welcome screen at power-up. You can also
show or hide the welcome screen from the menu.*
After clearing the welcome screen, the [NAVIGATION WARNING] screen appears*.
Read the warning, then click [OK].
*: For vessels with more than one TZtouch2 on the same network, when this message
is confirmed on any unit, it is also confirmed on the other networked TZtouch2 units.
The color of the lamp in the power switch changes according to equipment state.
Green: Equipment is powered.
Orange: Equipment is not powered but power is flowing to the equipment.
) on the front panel controls the power.
TZTL12F/TZTL15F
1. SYSTEM INTRODUCTION
Power
switch
TZT2BB
1-11