Language; Man Overboard (Mob) - Furuno NavNet TZtouch3 Series Operator's Manual

1.17

Language

The default interface language is English (United States). To change the language, do
as follows:
1. Go to the Home screen, then tap [Settings]→[General]→[Language].
2. Tap the language to use. The message "APPLICATION HAVE TO RESTART
NOW! DO YOU WANT TO RESTART APPLICATION?" appears.
3. Tap [OK].
The system takes approximately five minutes to optimize the system for the new
language setting,
1.18

Man Overboard (MOB)

The MOB function is used to mark the location of man overboard, from the plotter and
radar displays. At the moment the MOB function is activated, the MOB mark is put at
the current position, on both the plotter and radar displays.
How to mark the MOB position
Tap [MOB] on the Home screen. The plotter display opens, the MOB mark (
at the location at the moment MOB was activated, and the MOB location is automati-
cally set as destination. For the TZT12F, long push the [EVENT/MOB] key to enter the
MOB mark.
At the moment of activation the following occurs.
• The message "MOB" flashes in the status bar, with yellow characters on a red back-
ground. The aural alarm sounds if it is enabled. Tap the status bar to stop the flash-
ing indication and silence the aural alarm.
• The MOB mark is highlighted.
• A yellow line connects between the MOB mark and current location. This line shows
the straightest course between own ship and the MOB mark.
• If a FM-4800 VHF Radiotelephone is connected to the same network, the MOB in-
formation is also sent to the FM-4800 and can be sent as a DSC message.
MOB mark on the plotter display
1. SYSTEM INTRODUCTION
MOB mark on the radar display
) is
1-37