Speed Alarm; Anchor Watch Alarm - Furuno NavNet TZtouch3 Series Operator's Manual

2. CHART PLOTTER
2.10.4

Speed alarm

The speed alarm tells you when the speed of your ship is over or under the limit set.
Set the value at [Speed Alarm Value].
Note: Requires connection to appropriate sensor.
1. Tap [Speed Alarm] on the [Alarm] menu.
2. Tap [Over] or [Under].
3. Tap [Speed Alarm Value] to display the software keyboard.
4. Set the value for [Over] or [Under] then tap [ ].
5. Tap the close button to finish.
Note: To disable this alarm, turn it off at step 2 of the above procedure.
2.10.5

Anchor watch alarm

The anchor watch alarm tells you that your ship has moved a distance greater than
the set value when the ship must not be moving.
Your ship's position where you
start the anchor watch alarm.
1. Turn on [Anchor Watch Alarm] in the [Alarm] menu.
2. Tap [Anchor Watch Alarm Value] to display the software keyboard.
3. Set the value, then tap [ ].
4. Tap the close button to finish.
Note: To disable this alarm, turn it off at step 1 of the above procedure.
2-16
Alarm
setting
: Alarm area