Microsd Cards - Furuno NavNet TZtouch3 Series Operator's Manual

1. SYSTEM INTRODUCTION
1.11

MicroSD Cards

This equipment uses microSD cards for chart cards and data storage (tracks, routes,
points, boundaries, catches, photos, and setting data. With use of the SDU-001 or a
SD card reader, SDXC (Secure Digital Extended Capacity) cards can also be used.
How to insert a microSD card
Before inserting a chart card in the multi function display, turn off the power.
Unfasten two
screws.
Push card into slot
and close cover.
Chart card drive (multi function display)
How to format a microSD card/SD card
You do not normally need to format a data microSD card. If the card becomes unread-
able, format the card with a formatting program that is compatible with the specifica-
tions of the card. Formatting a chart card will erase all chart data on the card.
How to remove a microSD card
1) Open the card drive cover.
2) Push the card to release the card from the card drive.
3) Remove the card with your fingers then close the lid (cover).
About the microSD cards
• Handle the cards carefully. Improper use can damage the card and
destroy its contents.
• Make sure the slot lid (cover) is closed at all times.
• Remove a card with only your fingers. Do not use metal instruments
(like tweezers) to remove the card.
• Do not remove a card while the device is transferring or accessing information.
1-28
Push card
Open cover.
into a slot
and close
cover.
SD card unit (SDU-001)