How To Turn The Power On/Off; Turn The Power On/Off; Lock The Key Operation - Furuno MU-152 Operator's Manual

3. OPERATION
3.2

How to Turn the Power On/Off

This section shows how to turn on/off the monitor unit and the key lock function.
3.2.1

Turn the power on/off

How to turn on/off the power depends on the setting of the slide switch. The slide switch is set
when the monitor unit is installed. See section 1.8.
Note 1: When you restart the monitor unit, wait at least three seconds before powering the unit.
Note 2: The screen refreshes slower in low ambient temperatures.
Slide switch "ON"
The external equipment connected to the DVI port (DVI-D1 or DVI-D2) can power on/off the mon-
itor unit. See the external equipment's operator's manual.
Note 1: You can not turn on the power with the
Note 2: When you connect the cables to both DVI-D1 and DVI-D2 ports, turn off the power of both
connected equipment to turn off the monitor unit.
Note 3: When turning off the power with long press of the
following procedures to restart the MU-152.
1) Restart the equipment connected to the DVI-D1 or DVI-D2 port.
2) Disconnect the power cable from the MU-152, then connect it again.
Slide switch "OFF"
1. Press the /BRILL key to turn on the monitor unit.
2. Press and hold the
turn off the monitor unit. While you hold the key, the in-
dication shown in the figure to the right appears.
3.2.2

Lock the key operation

You can lock the monitor unit to prevent operation. Any key (except the
inoperative.
1. While you hold the PIP key, turn on the monitor unit. Keep the PIP key pressed for more than
five seconds.
Note: When the slide switch is ON, turn on the connected external equipment while pressing
the PIP key to turn on the monitor unit.
2. To cancel the lock, turn off the monitor unit and then turn it on while you hold the PIP key.
Keep the PIP key pressed for more than five seconds.
Note: The menu is not displayed when the monitor unit is locked. All menu settings retain their
value from before the monitor unit is locked.
/BRILL key for three seconds to
18
/BRILL key on the MU-152.
/BRILL key on the MU-152, do the
SHUT DOWN
This monitor will shut down in three seconds.
/BRILL key) will be