Using The Remote Controller; Pairing Addresses - Panasonic S-3650PU3E Technical Data & Service Manual

8-2-1-8. Using the Remote Controller

• Hold the remote controller with your hand and point its transmitter at the receiver. When the signal is received properly,
it will beep.
• Signals can travel a direct distance of 6 metres. This distance should be used only as a guide. It depends on battery strength.
• Make sure nothing is between the remote controller and the receiver that could block the signal.
• Do not leave the remote controller in direct sunlight, where the wind from the air conditioner can blow directly on it, or near
any other heat source.
• Take care not to drop, throw, or wash the remote controller with water.
• The signal from the remote controller may not be received in rooms with rapid start fluorescent lighting or inverter lights.
For more information, please contact the dealer where the product was purchased.
Wall Mount Use
■
Mounting the holder
1. Fasten the remote control holder with screws.
2. Slide the remote controller down into the holder.
• Press from the location you wish to mount the remote
controller and make sure the signal is received properly.
Note
• You cannot operate if the distance between the
remote controller and the receiver is greater than
that signals can travel.
■
Detaching the controller
1. Pull the remote controller up.

8-2-1-9. Pairing Addresses

When more than 1 indoor units are installed in the same room with a compatible remote controller, addresses can be set up to
avoid crosstalk.
You can control up to 6 indoor units individually by the supported remote controller by pairing the address on the remote
controller and the number on the address switch on the receiver.
There are separate address settings: receiver addresses for the receivers, and transmitter addresses for the remote controller.
Units will not be controlled if the setting do not match.
Screws (supplied)
Remote control holder
8-2-1-7
8