Panasonic S-3650PU3E Technical Data & Service Manual page 239

E09 More Than One Remote Controller Set to Main Error
1. Error Detection Method
It is judged an error when more than one remote controller in a remote control group is set as the main remote controller.
Forgot to set one remote controller to sub in a 2-remote control group.
•
• When using one wireless and one wired remote controller in a control group, forgot to set one of them to sub.
2. Error Diagnosis
1 Remote
1-1 Set one of the 2 remote controllers to sub.
controller
•
Method for setting a remote controller to sub
<CZ-RTC4>
1. Press and hold +
A
2. This will display , the CODE No. "01" and the SET DATA "0001" or the like on the remote controller's display.
3. Press / buttons to select the CODE No. to "01".
4. Press / buttons to select the SET DATA to "0000". (0000: Sub 0001: Main)
5. Press button (Once the display changes from flashing to steady, the setting is complete).
6. Once you press button, the remote controller returns to its normal display.
<CZ-RTC5B>
1. Press and hold +
2. Press / buttons to select the "3. RC. setting mode" and press the
3. The Code no. "01" and the Set data "0001" or the like on the remote controller's display.
4. Press / buttons to select the Code no. to "01" and press the
5. Press / buttons to select the Set data to "0000" (0000: Sub 0001: Main) and press the
6. Press button. After selecting [YES], the unit restarts.
Wireless remote controller
CZ-RWRC3
Factory default:
OFF (1 – 4)
Switch
1 2 3 4
Address switch (1 – 3)
CZ-RWRU3
PCB cover
Receiver PCB
buttons for several seconds simultaneously.
+ buttons for 4 seconds or more simultaneously.
Use this to set Main/Sub for the remote controller and the receiver.
Set one to [Main] and the other to [Sub].
Factory default: [Main]
It is recommended to set the wired remote controller to [Main].
M a n i S / u
Main/Sub
switch (4)*
Main/Sub switch position
OFF: Main
ON: Sub
Screw Factory default:
OFF (1 – 4)
ON
1 2 3 4
Main/Sub
switch (4)*
OFF: Main
ON: Sub
Address switch
(1 – 3)
* When using the infrared remote controller and the wired remote controller in combination,
set the wired remote controller to [Main].
.
button.
button.
Main/Sub setting
b
1 2 3 4
5-2-1-10
button.
M A N I S U B
1 2 3 4
5