Test Run Using The Remote Controller - Panasonic S-3650PU3E Technical Data & Service Manual

2-3-1-4. Test Run Using the Remote Controller

CZ-RTC5B (High-spec wired remote controller)
(1) Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the LCD display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Sel. Page [
(2) Press the or
If you wish to see the next screen instantly, press the
or button.
Select "4. Test run" on the LCD display and press the
button.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Sel. Page [
(3) Press the button. "TEST" will be displayed
on the LCD display.
TEST
[ ] START
CZ-RTC4 (Timer remote controller)
(1) Press the remote controller
Then press the
" " appears on the LCD display while the test run is in progress.
The temperature cannot be adjusted when in Test Run mode.
(This mode places a heavy load on the machines. Therefore use it
only when performing the test run.)
(2) The test run can be performed using the HEAT, COOL, or FAN
operation modes.
N OT E
The outdoor units will not operate for approximately 3 minutes after
the power is turned ON and after operation is stopped.
(3) If correct operation is not possible, a code is displayed on the remote
controller LCD display.(Regarding the alarm contents,
see section "2-3-1-5. Contents of Remote Controller Switch Alarm Display")
(4) After the test run is completed, press the
Check that " " disappears from the LCD display.
(To prevent continuous test runs, this remote controller includes a timer function that cancels the test run
after 60 minutes.)
* If the test run is performed using the wired remote controller, operation is possible even if the cassette-type
ceiling panel has not been installed. ("P09" display does not occur.)
, and buttons
20:30 (THU)
] Confirm
button to see each menu.
20:30 (THU)
] Confirm
20:30 (THU)
button for 4 seconds or longer.
button.
button again.
Change the display from "OFF" to "ON" by pressing the
or button. Then press the
Test run
Change
(4) Press the
Test run setting mode screen appears on the LCD
display.
Type U3
TEST
MO
COOL
Type F3
TEST
MO
COOL
2-3-1-2
20:30 (THU)
[ ] START
CZ-RTC5B
20:30 (THU)
Test run
ON
[ ] Confirm
button. Test run will be started.
20:30 (THU)
DE
FAN SPEED
FLAP
20:30 (THU)
DE
FAN SPEED
FLAP
(1) (4) (1)
2
button.
CZ-RTC4