Panasonic S-3650PU3E Technical Data & Service Manual page 284

When the operating mode at the priority remote controller is changed, the operating modes of other remote
controllers change as shown below.
Mode change at priority remote controller Operating modes at other remote controllers
Current mode
Cooling or dry
Heating
Cooling
Heating
Cooling or dry
Heating
Item code
Fan speed setting when
05
heating thermostat is OFF
Heating intake
06
temperature shift
07
Electric heater installation
Humidifying when heater
08
thermostat is OFF
Permit/prohibit automatic
0D
heating/cooling
7
0F Cooling-only
New mode
Cooling or dry
Heating
Fan
Heating
Cooling
Fan
Cooling
Dry
Dry
Heating
Dry
Fan
Cooling
Fan Dry
Fan
Heating
Fan
Fan
Item
Changes the fan speed setting when the heating thermostat is OFF.
Shifts the intake temperature during heating.
Can be set when the body thermostat is used.
Set when cost distribution is performed using an AMY central control
system or similar system, and when an optional electric heater is installed.
(This is unrelated to control of the electric heater.)
Normally humidifying does not occur when the thermostat is OFF during
heating operation. However, this setting can be changed in order to
increase the amount of humidifying.
Caution: In order to avoid water leakage and damage to the fan, do not use
this setting unless a vaporizing humidifier is used.
This setting can be used to prevent the automatic heating/cooling display
on the remote control if the unit configuration permits automatic heating/
cooling operation.
This setting allows a heat pump indoor unit to be operated as a cooling-
only unit.
Current mode
Heating
Fan (not changed)
Cooling
Fan (not changed)
Cooling (not changed)
Dry (not changed)
Cooling
Fan (not changed)
Cooling (not changed)
Dry (not changed)
Fan (not changed)
Heating (not changed)
Fan (not changed)
Description
7-11
New mode