Panasonic S-3650PU3E Technical Data & Service Manual page 119

Parts mounted on ceiling panels
● Details of parts
Part
Insulator
name
<11>
1
Slit
Shape
Slit
Perforations
(Receiver used for
ECONAVI)
No. of
2
parts
● Procedure for attaching the parts
1. Remove the covers in the four corners. (Fig. 1-11-1-1-12)
2. Fit the ceiling panel to the indoor unit.
(For details on how the ceiling panel is to be fitted, refer to the installation instructions which are provided with the
ceiling panel.)
3. Fit the insulators <11> to <13> onto the four corners of the ceiling panel exactly as shown in Fig. 1-12-1-2-13.
4. Fit the cover in place. The cover can fall off in this state so be absolutely sure to secure it in place using the fixing screws.
Fig. 1-11-1-1-12
<When mounting the parts onto the receivers (Fig. 1-11-1-1-14)>
Cut out along the perforations the insulators <11>, <12> and/or <13> that fit the mounting location, mount them by matching
them to the shape of each receiver, and attach the covers to the ceiling panel.
* Be absolutely sure to use the maximum dimensions of 910 mm × 910 mm for the extent of the ceiling opening so that the
ceiling surface and insulators will not absorb any shocks.
(For details on how the ceiling panel is to be fitted, refer to the installation instructions which are provided with the
ceiling panel.)
For Wireless remote controller receiver
Datum for
attaching the parts
Insulator Insulator
<12>
2
Slit Perforations Slit
(Receiver used for
wireless remote controller)
1
<11>
Cover
Refrigerant
piping side
<13>
<14>
<12><13>
Insulator that has been cut out
along its perforations
Fig. 1-11-1-1-14
1-11-1-1-43
Insulator
<13> <14>
Slit
3
Perforations
1 2
3
Fig. 1-11-1-1-13
For ECONAVI panel
Datum for
attaching the parts
Insulator Insulator
<15> <16>
1 1
<12>
Drain piping
side
<11>
<16>
Used to block the square
hole of the <15> insulator
<15>
<11>
Insulator that has been
cut out along its perforations
1