Otto Bock E-MAG Active 17B203-L Instructions For Use Manual page 39

29
30
31
32
17B203=* E-MAG Active
Insert the electronics into the receptacle.
Fasten the electronics using the supplied screws at a
maximum torque of 1 Nm.
Connect the electronics cable to the orthotic joint:
• Loosen the screws of the cover on the E-MAG
orthotic joint.
• Remove the cover.
• Apply silicone grease to the contacts of the elec­
tronics cable.
• Connect the electronics cable to the plug contacts.
INFORMATION: When removing the joint cover of
the E-MAG, ensure that the roller (item 2) stays
positioned on the actuating bolt (item 1) to enable
secure temporary unlocking.
Preparation for use
39