Otto Bock E-MAG Active 17B203-L Instructions For Use Manual page 34

Preparation for use
12
13
14
15
34
Mill the cable groove into the lamination dummy.
Position the lamination dummies for the electronic com­
ponents on the model.
Measure the length of the supplied cable dummies:
For the lamination dummy, 7 mm between the knee
•
joint and electronics.
• Perlon wire for the cable connecting the electronics
to the battery.
Secure the lamination dummies for the electronic com­
ponents on the model with a strip of double-sided
adhesive tape. Fill the edges between the dummies and
the socket with plasticine in order to achieve a smooth
transition.
Push down the protruding edges with a spatula so
there is a distance of 2 mm between the dummies and
plasticine.
Fasten the cable dummies in the designated recesses
of the electronics and battery dummies:
• From the orthotic knee joint to the electronics.
• From the electronics to the battery.
17B203=* E-MAG Active