Taylor 810 Series Operator's Manual page 35

One-Function Cook Cycle Screen
The following is an example of a one-function cook cycle
screen. The first line function default is REMOVE IN.
Note: Sec, Alarm, and Gap must be set.
Figure 6-34
Two-Function Cook Cycle Screen
The following is an example of a two-function cook cycle
screen. The two functions shown are TURN IN and
REMOVE IN.
The total cook time, or REMOVE IN time, is 100 seconds.
The first function is 60 seconds, and the second function
is 100 seconds. Each timing function is accumulative.
REMOVE IN is always the last part of the cook cycle.
Figure 6-35
Operating Procedures
Three-Function Cook Cycle Screen
The following is an example of a three-function cook
cycle screen. The three functions are SEAR IN, TURN
IN, and REMOVE IN.
The total cook time, or REMOVE IN time, is 120 seconds.
The first function is set at 30 seconds, the second
function at 60 seconds, and the third function at 
120 seconds. Each timing function is accumulative.
REMOVE IN is always the last part of the cook cycle.
Standby Procedures
Whenever the grill is idle and product is not being
cooked, the upper platen should be placed in the Standby
position to conserve energy.
1. To place the upper platen in the Standby position
from the open position, press the STANDBY button
twice, waiting 1 second between button presses.
The control will display GOING TO STANDBY and then
change to display STANDBY.
Model 810, 812, 820, 822, 828 Series
OPERATING PROCEDURES
Figure 6-36
Figure 6-37
6
6-13