Taylor 810 Series Operator's Manual page 11

CAUTION! This grill must be installed on a
level surface. Failure to comply may result in personal
injury or machine damage.
CAUTION! For thorough cleaning, the
machine must be pulled away from the wall. Before
moving the machine, remove the grease cans. Turn off
the gas at the quick connect shutoff valve on the flexible
hose. Disconnect the gas quick connector. Disconnect
the tether to the machine, located on the back panel of
the machine.
To return the machine to its original position, reverse
these steps. Use extreme caution to smoothly and slowly
roll the machine back into place.
Failure to do so may cause the machine to tip and can
result in severe equipment damage or personal injury.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please see
the cleaning section of this manual for the proper
procedure to clean this machine.
IMPORTANT! Access to the service area of
the machine is restricted to persons having knowledge
and practical experience with the appliance, as far as
safety and hygiene are concerned.
NOTICE! All warning labels that have been
attached to the machine point out safety precautions to
the operator.
Failure to follow these instructions can result in burn
injuries.
Safety
This machine is made in America and has American
sizes on hardware. All metric conversions are
approximate and vary in size.
Noise Level: Airborne noise emission does not exceed
70 dB(A) when measured at a distance of 3.3 ft. (1.0 m)
from the surface of the machine and at a height of 5.25 ft.
(1.6 m) from the floor.
These instructions are valid only if the country code
symbol appears on the appliance. If the symbol does not
appear on the appliance, refer to the technical
instructions which give the necessary instructions for
adapting the appliance to the utilization conditions of that
country.
Model 810, 812, 820, 822, 828 Series
SAFETY
3
3-3