Taylor 810 Series Operator's Manual page 10

SAFETY
WARNING! DO NOT use a water jet or spray
excessive water on or anywhere near the machine.
Failure to follow this instruction may result in serious
electrical shock and cause permanent electrical and
mechanical damage to internal parts. 
Failure to follow this instruction may result in:
• Serious electrical shock
3
• Burns from hot steam
• Liquid collecting inside the machine and
destroying electrical components
WARNING! Avoid injury.
• DO NOT operate this machine unless it is
properly grounded.
• DO NOT operate this machine with larger fuses
than specified on the data label.
• DO NOT operate this machine unless all service
panels and access doors are attached with
screws.
• All repairs must be performed by an authorized
Taylor service technician.
• The main power supplies to the machine must
be disconnected prior to performing any repairs.
• Only authorized Taylor service technicians or
licensed electricians may install a plug or
replacement cord on this machine.
• Stationary machine which are not equipped with
a power cord and a plug or other device to
disconnect the machine from the power source
must have an all-pole disconnecting device with
a contact gap of at least 1/8 in. (3 mm) installed
in the external installation.
• Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices such
3-2
as a GFI to protect against the leakage of
current installed by the authorized personnel to
the local codes.
•
oil-resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other
equivalent synthetic elastomer-sheathed cord
(code designation 60245 IEC 57) installed with
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion. 
If the supply cord is damaged, it must be
replaced by the manufacturer, service agent, or
similarly qualified person, in order to avoid a
hazard.
Failure to follow these instructions may result in severe
injury or death from electrocution.
cool the upper platen or the lower cook surface. Failure
to follow this instruction may result in:
•
•
•
destroying electrical components
lungs, and all parts of the body from potential harm when
using any chemical cleaner. Failure to follow this
instruction may result in a chemical burn.
cleaners other than approved food-service cleaners and
degreasers. Failure to comply may cause illness to the
consumer and may also damage grill surfaces.
Model 810, 812, 820, 822, 828 Series
Supply cords used with this machine shall be
WARNING! DO NOT use cold water or ice to
Serious electrical shock
Burns from hot steam
Liquid collecting inside the machine and
WARNING! Take caution to protect eyes,
CAUTION! DO NOT use any abrasives or
Safety