5-34
2. Main Menu Screen
9-2.
USB Test
This section describes how to check the connection to USB-A (master) port.
Checking the Connection Status
If the lamp on the screen shows [No Connected], the USB device is not identified.
When the lamp shows [Connected], the USB device is identified.
Example: Checking the connection with USB memory or USB-CFREC
9-3.
Print Test
Pressing the [Print Check] switch on the I/O Test screen displays the Print Test screen. This screen is
used to perform a print test with a printer connected.
Displays a printer
port name. *
* The printer port name specified on the V-SFT-5 editor is displayed. Either [USB-A (Host)] or [USB-B
(Device)] is displayed.
Print Test Result Example
Pressing the [Print] switch executes a print test. When the print test has been finished successfully, a
test result is printed out as shown below.
Disconnected
!"#$%&@
0123456789
!"#$%&@
0123456789
!"#$%&@
0123456789
!"#$%&@
0123456789
!"#$%&@
0123456789
!"#$%&@
0123456789
!"#$%&@
0123456789
Print Test screen
ABCDEFGHIJKLMNO
ABCDEFGHIJKLMNO
ABCDEFGHIJKLMNO
ABCDEFGHIJKLMNO
ABCDEFGHIJKLMNO
ABCDEFGHIJKLMNO
ABCDEFGHIJKLMNO
Connected
The I/O Test screen is
displayed again.
Performs a print test.