Lan Connector (Ts1100I/Ts1070I Only); Lan Connector; Wiring - Fuji Electric MONITOUCH TS Series Hardware Specifications

6.

LAN Connector (TS1100i/TS1070i Only)

LAN Connector

This connector is used to connect a controller via Ethernet.
The LAN connector supports 100BASE-TX/10BASE-T.
• TS1100
The LAN connector pins correspond to signals as given below.
Specification: IEEE802.3 (u)-compliant, supporting UDP/IP, TCP/IP, and Auto-MDIX
8 7 6 5
The LAN connector is associated with LEDs as given below.
Green LED

Wiring

When using the LAN port, keep the LAN cable away from the power supply cable as
CAUTION
much as possible.
Use a commercially available cable. Using a self-made cable may cause an error in network
connection.
Recommended cable: 100 Ω UTP (unshielded twist-pair) cable, category 5, max. 100 m long
* Both straight and cross cables are usable, irrespective of the presence or absence of a hub.
Bottom view
LAN
4 3 2 1
LED Status
LAN
Green
ON
Orange LED
ON
Blinking
6. LAN Connector (TS1100i/TS1070i Only)
• TS1070
Bottom view
Pin No. Signal
1 TX+
2 TX−
3 RX+
4 NC
5 NC
6 RX−
7 NC
8 NC
Orange
ON Connected via 100 BASE-TX
OFF Connected via 10 BASE-T
ON/OFF Sending/receiving data
2-25
Contents
Ethernet send signal (+)
Ethernet send signal (−)
Ethernet receive signal (+)
Not used
Not used
Ethernet receive signal (−)
Not used
Not used
Contents
2