Data Loading - Fuji Electric MONITOUCH TS Series Hardware Specifications

6-2 1. Error Messages
Error Messages
Error code received
Break
Invalid memory
(Mitsubishi CPU)
Format
Compare
(HIDIC S10)
NAK
Transaction Error
(Allen-Bradley PLC)
Communication Error
Count error
(Mitsubishi CPU and Q link
unit)
Command error
(Mitsubishi CPU and Q link
unit)
2.

Data Loading

If an error is detected on the screen data in the RUN mode, the following messages are displayed on
the TS series.
Error Messages
Screen No. Error
Error : XX (XX : XXX)
Contents
An error code was sent by a controller.
(NAK)
The controller's SD remains at the low level.
You specified an address that exceeds the
memory range of the PLC that you are linked
to.
The code of the received data is invalid.
Transmission data and received data are
different.
A NAK code is received.
Transmitted transaction data and received
transaction data are not in agreement.
An unclear communication error is detected.
The expected data amount is different from the
count value.
The response code differs from the expected
code.
Screen No. Error
Contents
There is no setting for the
received screen.
There is an error in the
created screen data.
Examine the controller error code and solve
the problem.
Examine the connection between the
controller's SD and the TS's RD.
Check the type and range of memory that you
set.
1. Confirm link unit settings.
(After making settings, cut power to the
controller.)
2. On the V-SFT-5 editor, select [System
Setting] → [Device Connection Setting]
and check the settings.
3. If errors only occur from time to time, a
noise-based communication error may be
present.
Error : XX (XX : XXX)
At the start of communications, the TS series regards the value
in the read area "n + 2" as the screen number.
Check that this value is an existing screen number on the
controller.
According to the item number and the sub-item number
displayed on the TS series, find the edited screen where the
error occurs. Check the contents of the error (error number)
and remove the error.
Error : XX (XX : XXX)
For details on the item number and sub-item number, refer to
the TS Series Reference Manual.
Solution
Solution
Sub-item No.
Item No.
Error No.