Table of Contents
Advertisement
5-10
2. Main Menu Screen
Setting using the V-SFT Editor
1. Select [System Setting] → [Ethernet Communication] → [Local Port IP Address] on the V-SFT
editor. The [IP Address Setting] dialog is displayed.
2. Check the [Set IP] check box and set each item.
Select IP Address from
Network Table
IP Address
Default Gateway
Subnet Mask
Port No.
Send Timeout
Retrials
Memory Protect
* For more information on setting items, refer to page 5-11.
3. Click [OK].
4. Transfer the screen data to the TS unit. Check the IP address displayed under [Ethernet
Information] on the Main Menu screen.
*
*
*
*
Internal Memory
Memory Card Memory
This is valid when the IP address of the TS has been registered in the
network table. Select a network table number from 0 to 99 to set the IP
address.
Set the IP address for the TS.
Set the default gateway.
Set the subnet mask.
When this box is not checked, the subnet mask is automatically assigned
based on the byte at the extreme left of the IP address.
Example:
IP address 172.16.200.185: "255.255.0.0" is set.
IP address 192.168.1.185: "255.255.255.0" is set.
Set a port No. 1024 to 65535, except for 8001.
Set a timeout period for transmitting macro commands SEND, EREAD or
EWRITE, or macro commands for MES.
0 to 255
Set the number of retrials to be performed when a time-out occurs.
Check either check box to write-protect the memory from computers or
other stations.
Advertisement
Table of Contents
