1.
Mounting Procedure
Mounting Procedure
1. Insert the TS unit into the mounting panel (max. thick: 5 mm).
* When using an optional waterproof gasket "TS1xx0-WP", firmly sandwich the gasket between
the mounting panel and the TS series.
Panel cut-out hole
Y
Mounting panel
2. Fit the supplied four fixtures onto the screws of the TS series. Tighten them with the supplied four
nuts. (Tightening torque: 0.3 to 0.4 N•m)
* When the TS unit is attached to the mounting panel, the fixtures and frame grounds (FG) are
connected.
Screw
Mounting panel
• Nut dimensions
8
14.0
X
• Fixture
• Dimensions of a tightened fixture that lies off the edges of the
dimensions
TS unit
4.2
17.5
8.5
1. Mounting Procedure
Panel cut-out dimensions
Model
X
+0.5
TS1100
257.0
-0
+0.5
189.0
TS1070
-0
X
Y
Fixture
Nut
8.5
Back of the TS unit
3-1
3
Y
199.0
+0.5
-0
134.0
+0.5
-0
Unit: mm
(
Unit: mm)