Fuji Electric MONITOUCH TS Series Hardware Specifications page 30

V-SFT-5 Setting
Click [System Setting] → [Device Connection Setting] → [Others] → [Printer]. In the tab window,
select [USB A] for [Connect to:] and a desired option for [Type].
USB Memory
By inserting a USB memory device (commercially available) into the TS series, the device can be used
for screen data transfer or historical data saving.
Connection Example
V-SFT-5 Setting
Click [System Setting] → [Storage Setting]. In the dialog, select [USB Port] for [Storage
Connection Target].
Notes on Handling the USB Memory
1. The TS series can recognize USB memory in FAT or FAT32 file systems.
2. Do not turn off the unit while the TS series is accessing the USB memory.
3. Make a backup copy of the USB memory at regular intervals.
4. If a disk error occurs and data read/write operation is disabled, execute ScanDisk on Windows and
try to restore the device.
If not restored, format the device. Note that formatting will completely delete any stored data. (For
information on executing ScanDisk on Windows, refer to the manual for Windows.)
5. The number of write cycles for a USB memory is limited. Consequently, frequent writing at short
intervals may shorten the service life of the USB memory. When using USB memory to save
sampling data, be aware of the sampling time. Also, avoid repeated writing using a CYCLE macro
command.
6. When disconnecting the USB memory, open the Main Menu screen or hold down the [Storage
Removal] switch on the screen.
TS
USB memory
USB-A
5. USB Connector 2-13
2