Thank you for selecting the Techno Shot series (TS series).
For correct set-up of the TS series, you are requested to read through this manual to understand more about the
product.
The manuals shown below are related manuals for the TS series. Refer to them as necessary.
Manual Name
TS Series Training Manual
TS Series Connection Manual
V8 Series Reference Manual
V8 Series Reference: Additional Functions
V Series Macro Reference
V8 Series Operation Manual
For further details about controllers (PLCs, temperature controllers, etc.), refer to the manual issued by each
controller manufacturer.
Notes:
1. This manual may not, in whole or in part, be printed or reproduced without the prior written consent of
Hakko Electronics Co., Ltd.
2. The information in this manual is subject to change without prior notice.
3. Windows and Excel are registered trademarks of Microsoft Corporation in the United States and other
countries.
4. All other company names or product names are trademarks or registered trademarks of their
respective holders.
5. If the specifications of the software do not correspond with the contents of this manual, the software
specifications have priority.
Preface
Contents
Screen configuration procedures using V-SFT
version 5 are explained with examples.
Connecting the TS series with controllers and
setting their communication parameters are
explained.
The functions and instructions of the V8 series are
explained.
Additional functions and operations of the V8
series that are available with V-SFT version
5.1.0.0 and later are explained.
An overview of macros as well as macro editor
operations and macro command descriptions are
explained in detail.
Information related to the operations of V-SFT
version 5, such as software composition, editing
procedure or limitations, is explained.
Reference No.
1203NE
2203NE
1055NE
1060NE
1056NE
1058NE