Fuji Electric MONITOUCH TS Series Hardware Specifications page 34

V-SFT-5 Setting
Refer to the previous "V-SFT-5 Setting":
• Printer (page 2-12)
• USB Memory (page 2-13)
• USB CF Card Recorder (USB-CFREC) (page 2-14)
• Barcode Reader (page 2-15)
• Keyboard (page 2-15)
Notes
• A barcode reader and a keyboard cannot be connected to a USB hub at the same time.
• Two or more barcode readers or keyboards cannot be connected to a USB hub at the same time.
• A maximum of two USB hubs can be connected (cascaded) to the TS unit.
Note that performance will decrease when two USB hubs are connected.
• When a USB hub connected to the TS unit is powered through its accessory power supply
adaptor, do not turn off the adaptor or disconnect the connector between the adaptor and the USB
hub.
Doing so may cause insufficient power supply to the TS unit resulting in faulty operation such as
repeated restarting.
• When connecting two USB hubs to the TS unit, supply the power to each USB hub using its
accessory power supply adaptor.
Even when connecting only one USB hub, use its power supply adaptor (if the one is supplied with
a hub).
• Before disconnecting the USB memory device or the USB cable of the USB CF card recorder
USB-CFREC, open the Main Menu screen on the unit or hold down the [Storage Removal] switch
on the screen.
5. USB Connector 2-17
2