Fuji Electric MONITOUCH TS Series Hardware Specifications page 51

4-2 1. Coin-type Lithium Battery
Safety Instructions on Handling the Battery
Lithium batteries contain combustible material such as lithium or organic solvents. Mishandling may
cause heat, explosion or ignition resulting in fire or injury. To prevent accidents, pay attention to the
following cautions when handling lithium batteries.
CAUTION
SRAM Area Backup Procedure
Before replacing the battery, be sure to make a backup copy of data stored in SRAM using the
V-SFT-5 editor.
When Using the V-SFT-5 Editor:
1) Connecting a USB cable
2) Starting the V-SFT-5 editor
3) Displaying the [Transfer] dialog
4) Selecting data to be transferred
5) Starting SRAM data transfer
6) Saving the SRAM data
* To transfer the "∗.RAM" data saved as a backup to the TS unit, click the [PC −>] button
When Using Storage:
For backing up data to storage such as a USB memory, refer to "Saving Backup Copies of
SRAM" (page 5-24).
• Be sure to discharge static electricity from your body before battery replacement.
• Use the recommended battery for replacement.
• Rough handling of the battery may cause fire or chemical burn hazard.
• Do not disassemble, incinerate or heat the battery.
• Observe local and governmental regulations when disposing of waste batteries.
• Keep batteries out of reach of children. (If swallowed, immediately consult a doctor.)
• Never re-charge the battery.
• If the battery leaks or smells, the leaking battery electrolyte is flammable. Keep
from heat or flame.
Connect the TS unit and the computer with a USB cable.
Start the V-SFT-5 editor on the computer.
Click the [Transfer] icon. The [Transfer] dialog is displayed.
Select [Transfer Device: Display] and [Transfer Data: SRAM Data].
Do not check [ Use Simulator].
Click the [PC <−] button under [Transfer]. Data transfer from the SRAM is started.
When the SRAM data has been transferred, the [Save As] dialog is displayed on the
computer. Save the data as a backup copy. The extension is "∗.RAM".
under [Transfer] in step 5.