Error Messages; Communication Error - Fuji Electric MONITOUCH TS Series Hardware Specifications

1.

Error Messages

There are five kinds of error messages displayed on the TS series:

1. Communication Error

2. Data Loading
3. Warning
4. Touch switch is active.
1. Communication Error
When communication is not established between the TS series and a controller, or any abnormality
(noise etc.) is detected, the following messages are displayed on the TS series.
• Comm. Error Handling: Continue
Error Messages
Although a request to send is given to a
Time-Out controller, no answer is returned within the
specified time.
Parity An error occurred in parity check.
Although the stop bit must be [1], it is
Framing
detected as [0].
After one character is received, the next
Overrun character is received before internal
processing is completed.
The check code in the controller response
Check code error
was not correct.
* If the above error messages are displayed on the TS series without establishing communication
between TS and PLC, test the solution of remark "1". If the error occurs suddenly in
communication, test the solution of remark "2".
• Comm. Error Handling: Stop
Contents
1. Check settings in the [Communication
2. Check the cable connection.
3. Data may be disrupted because of
1. Check the cable connection.
2. Data may be disrupted because of
1. Check settings in the [Communication
2. Check the cables and wiring.
3. Data may be disrupted because of
1. Check settings in the [Communication
2. Data may be disrupted because of
1. Check settings in the [Communication
2. Data may be disrupted because of
1. Error Messages
Solution
Setting] tab window of the [Device
Connection Setting] dialog.
noise. Fix noise.
noise. Fix noise.
Setting] tab window of the [Device
Connection Setting] dialog.
noise. Fix noise.
Setting] tab window of the [Device
Connection Setting] dialog.
noise. Fix noise.
Setting] tab window of the [Device
Connection Setting] dialog.
noise. Fix noise.
6-1
6
Remarks
1
2
1
2
1
2
1
2
1
2