NEC Express5800 Series User Manual page 61

Chapter 2 Preparations
(b) If an optional RAID Controller (N8103-128/149/150/151) is used
If using internal Hard Disk Drives in RAID System with an optional RAID Controller (N8103-128/149/150/151)
installed in the server, the SATA cable needs to be rewired.
• For 3.5-inch models: K410-240(00)
• For 2.5-inch models with up to 4 Hard Disk Drives: K410-240(00)
• For 2.5-inch models with 5 Hard Disk Drives or more: K410-240(00) and K410-204(00)
The SATA cable is connected to the SATA connector on the motherboard in the factory settings.
Jumper on motherboard (SWRAID)
Backplane for 3.5-inch Hard Disk Drive (J3)
Backplane for 2.5-inch Hard Disk Drive (J3)
Motherboard
N8103-128/149/150/151
Note
When installing an optional RAID Controller, start the BIOS Setup utility, select PCI
Configuration from the Advanced menu, and then make sure that the parameter
of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
Important
Do not change the mode to hibernate when building a RAID System.
Express5800/R110e-1E User's Guide
1. Installing Internal Optional Devices
3 2 1 3 2 1
Disabled
Enabled
(Default)
SWRAID 設定ジャンパ
SWRAID
Onboard SATA
Onboard SATA
N8103-128/149/150/151
controller
コントローラ
Onboard SATA
Onboard SATA
controller
コントローラ
61